(a) Bridge and car plates (dockboards). Bridge and car plates used afloat shall be well maintained and shall:
(1) Be strong enough to support the loads imposed on them;
(2) Be secured or equipped with devices to prevent their dislodgement;
(3) Be equipped with hand holds or other effective means to permit safe handling; and
(4) Be designed, constructed, and maintained to prevent vehicles from running off the edge.
3
3 When the gap to be bridged is greater than 36 inches (.91m), an acceptalbe means of preventing vehicles from running off the edge is a minimum side board height of two and three-quarter inches.
(b) Portable ramps. Portable ramps used afloat shall be well maintained and shall:
(1) Be strong enough to support the loads imposed on them;
(2) Be equipped with a railing meeting the requirements of § 1918.21(b), if the slope is more than 20 degrees to the horizontal or if employees could fall more than four feet (1.22 m);
(3) Be equipped with a slip resistant surface;
(4) Be properly secured; and
(5) Be designed, constructed, and maintained to prevent vehicles from running off the edge.
4
4 When the gap to be bridged is greater than 36 inches (.91m), an acceptable means of preventing vehicles from running off the edge is a minimum side board height of two and three-quarter inches.
[62 FR 40202, July 25, 1997, as amended at 65 FR 40944, June 30, 2000]
authority: 33 U.S.C. 941;
29 U.S.C. 653,
655,
657; Secretary of Labor's Order No. 12-71 (36 FR 8754), 8-76 (41 FR 25059), 9-83 (48 FR 35736), 1-90 (55 FR 9033), 6-96 (62 FR 111), 3-2000 (65 FR 50017), 5-2002 (67 FR 65008), 5-2007 (72 FR 31160), 4-2010 (75 FR 55355), 1-2012 (77 FR 3912), or 8-2020 (85 FR 58393), as applicable; and
29 CFR 1911
source: 62 FR 40202, July 25, 1997, unless otherwise noted.
cite as: 29 CFR 1918.25