(a) This subpart allocates rate authority to address the effects of decreases in the density of mail as measured by the sources identified in § 3030.161. The calculation of the additional rate authority corresponding to the change in density is described in § 3030.162.

(b) The Postal Service shall file a notice with the Commission by December 31 of each year that calculates the amount of density rate authority that is eligible to be authorized under this subpart.

(c) The Commission shall review the Postal Service's notice and determine how much, if any, rate authority will be authorized under this subpart. Any rate authority allocated under this subpart:

(1) Shall be made available to the Postal Service as of the date of the Commission's determination;

(2) Must be included in the calculation of the maximum rate adjustment authority in the first generally applicable rate adjustment filed after the Commission's determination; and

(3) May be used to generate unused rate authority, if unused, within 12 months of the Commission's announcement.

(a) The data needed for the calculation of the density rate authority in § 3030.162 shall be obtained from the values reported by the Postal Service as specified in paragraphs (b) through (d) of this section. When both originally filed and annually revised data are available, the originally filed data shall be used. When the originally filed data are corrected through a refiling or in the Commission's Annual Compliance Determination report, the corrected version of the originally filed data shall be used.

(b) Market dominant volume and total volume from the Revenue, Pieces, and Weight report, filed by the Postal Service under § 3050.25 of this chapter;

(c) Institutional costs and total costs from the Cost and Revenue Analysis report, filed with the Postal Service's section 3652 report (see § 3050.1(g) of this chapter); and

(d) The number of delivery points, from the input data used to produce the Total Factor Productivity estimates, filed with the Postal Service's section 3652 report.

(a) Formulas. (1) The formula for calculating the amount of density rate authority, in conformance with paragraph (b)(1) of this section, is as follows:

(2) The formula for calculating the percentage change in density, in conformance with paragraph (b)(2) of this section, is as follows:

(b) Calculation. (1) The amount of density rate authority available under this section shall be calculated in three steps. First, the percentage change in density during the most recently completed fiscal year shall be calculated using the formula in paragraph (a)(2) of this section as described in paragraph (b)(2) of this section. Second, this percentage change shall be multiplied by the institutional cost ratio, which is calculated as institutional costs for the most recently completed fiscal year divided by total costs for that fiscal year. Finally, this product shall be multiplied by negative 1 so that declines in density correspond to a positive increase in rates. If the result of this calculation is less than 0, the amount of additional rate authority shall be 0.

(2) The percentage change in density from the prior fiscal year shall be calculated as the ratio of volume to delivery points for the most recently completed fiscal year, divided by the same ratio for the prior fiscal year, and subtracting 1 from the quotient. The result is expressed as a percentage, rounded to three decimal places. To ensure that decreases in competitive product volume will not result in the Postal Service receiving greater additional rate adjustment authority under this subpart, the percentage change in density shall be calculated two ways: Using market dominant volume and using total volume. The greater of the two results (not using absolute value) shall be used as the percentage change in density from the prior fiscal year.