(a) Consistent with the objective of enhancing the national security by increasing DoD reliance on the U.S. commercial technology and industrial bases, you must include a provision in the TIA that addresses foreign access to technology developed under the TIA.
(b) The provision must provide, as a minimum, that any transfer of the:
(1) Technology must be consistent with the U.S. export laws, regulations and policies (e.g., the International Traffic in Arms Regulation at chapter I, subchapter M, title 22 of the CFR (22 CFR parts 120 through 130), the DoD Industrial Security Regulation in DoD 5220.22-R,
3
and the Department of Commerce Export Regulation at chapter VII, subchapter C, title 15 of the CFR (15 CFR parts 730 through 774), as applicable.
3 Electronic copies may be obtained at the Washington Headquarters Services Internet site http://www.dtic.mil/whs/directives. Paper copies may be obtained, at cost, from the National Technical Information Service, 5285 Port Royal Road, Springfield, VA 22161.
(2) Exclusive right to use or sell the technology in the United States must, unless the Government grants a waiver, require that products embodying the technology or produced through the use of the technology will be manufactured substantially in the United States. The provision may further provide that:
(i) In individual cases, the Government may waive the requirement of substantial manufacture in the United States upon a showing by the recipient that reasonable but unsuccessful efforts have been made to transfer the technology under similar terms to those likely to manufacture substantially in the United States or that under the circumstances domestic manufacture is not commercially feasible.
(ii) In those cases, the DoD Component may require a refund to the Government of some or all the funds paid under the TIA for the development of the transferred technology.
(c) You may, but are not required to, seek to negotiate a domestic manufacture condition for transfers of nonexclusive rights to use or sell the technology in the United States, to parallel the one described for exclusive licenses in paragraph (b)(2) of this section, if you judge that nonexclusive licenses for foreign manufacture could effectively preclude the establishment of domestic sources of the technology for defense purposes.
[68 FR 47160, Aug. 7, 2003, as amended at 85 FR 51246, Aug. 19, 2020]