Code of Federal Regulations > Title 40 > Chapter I > Part 63 > Subpart MMMMM > Appendix - Table 4 to Subpart MMMMM of Part 63

Regulations last checked for updates: Nov 22, 2024

Title 40 - Protection of Environment last revised: Nov 20, 2024

Appendix - Table 4 to Subpart MMMMM of Part 63—Initial Compliance With Emission Limits

As stated in § 63.8806, you must comply with the requirements to demonstrate initial compliance with the applicable emission limits in the following table:

For . . .	For the following emission limit . . .	You have demonstrated initial compliance if . . .
1. Each new, reconstructed, or existing loop slitter adhesive use affected source	Eliminate use of HAP-based adhesives	You do not use HAP-based adhesives.
2. Each new or reconstructed flame lamination affected source using a scrubber	Reduce HAP emissions by 90 percent	The average HAP emissions, measured over the period of the performance test(s), are reduced by 90 percent.
3. Each new or reconstructed flame lamination affected source using any other control device emissions by	Reduce HAP emissions by 90 percent	The average HAP emissions, measured over the period of the performance test(s), are reduced by 90 percent.
4. Each existing flame lamination affected source	Emit no more than 1.45 pounds per hour of HCl per flame lamination line	The average HCl emissions, measured over the period of the performance test(s) do not exceed 1.45 pounds per hour per flame lamination line.

[68 FR 18070, Apr. 14, 2003, as amended at 86 FR 64403, Nov. 18, 2021]

authority: 42 U.S.C. 7401

source: 57 FR 61992, Dec. 29, 1992, unless otherwise noted.