CLA-2-72:S:N:N1:117 865499
Ms. Nora Ishigaki
Milieu Information Service, Inc.
P.O. Box 6536
San Jose, CA 95150
RE: The tariff classification of cold-rolled stainless steel
from People's Republic of China.
Dear Ms. Ishigaki:
In your letter dated July 19, 1991 you requested
a tariff classification ruling.
The flat-rolled products you plan to import are of cold-
rolled stainless steel. The first item is .25 mm thick, 305 mm
wide and in coil form. The second item has a thickness of 3mm, a
width of 1000 mm and is cut to a length of 2000 mm. Once
imported, these products will ultimately be used as heat transfer
plates for water distillation research.
The applicable subheading for the merchandise in coils will
be 7220.20.1000, Harmonized Tariff Schedule of the United States
(HTS), which provides for flat-rolled products of stainless
steel, of a width of less than 600 mm, not further worked than
cold-rolled, of a width of 300 mm or more. The rate of duty will
be 10.1 percent ad valorem.
The applicable subheading for the merchandise which is cut
to length will be 7219.32.0060, Harmonized Tariff Schedule of the
United States (HTS), which provides for flat-rolled products of
stainless steel, of a width of 600 mm or more, not further worked
than cold-rolled, of a thickness of 3mm or more but less than
4.75 mm, not in coils, other. The rate of duty will be 10.1
percent ad valorem.
This ruling is being issued under the provisions of Section
177 of the Customs Regulations (19 C.F.R. 177).
A copy of this ruling letter should be attached to the entry
documents filed at the time this merchandise is imported. If the
documents have been filed without a copy, this ruling should be
brought to the attention of the Customs officer handling the
transaction.
Sincerely,
Jean F. Maguire
Area Director
New York Seaport