CLA-2-54:RR:NC:TA:352 C88474
Mr. Thomas McInerney
AEI Customs Brokerage Services
7240 Cross Park Drive
North Charleston, SC 29418
RE: The tariff classification of rectangular sheets of woven
olefin strip from China.
Dear Mr. McInerney:
In your letter dated May 1, 1998, on behalf of your client
Fritz Marketing, Inc. you requested a classification ruling.
The submitted sample is a plain woven fabric composed of a
combination of polyethylene and polypropylene. It is constructed
using polypropylene and polyethylene strips that vary in width.
60% of the strips have an apparent width of 5 millimeters or less
while 40% of the strips have an apparent width of more than 5
millimeters. Those strips that measure 5 millimeters or less meet
the dimensional criteria to be considered textile strip for the
purposes of the Harmonized Tariff Schedules. This product has been
coated on one side with a clear olefin coating that is not visible
to the naked eye. The sheets which have been cut from larger
pieces of fabric measure approximately 52 inches by 40 inches and
will be used for packing various commodities for transport. The
fabric weighs 70 g/m2 with the clear coating representing
approximately 20 g/m2.
This product is a composite good made in part of textile strip
and in part of plastic strips which are considered plaiting
material. While the quantity, surface area and the value of the
textile strips exceeds the plaiting material strips, the
differences in these factors are not overwhelming and the plaiting
material strips play a crucial role in the product. Therefore, it
is not possible to determine the essential character of this
fabric. General Rule of Interpretation 3(c) directs that if the
essential character of a composite good cannot be determined then
the good is classifiable under the heading that occurs last in
numerical order of those which equally merit consideration. Since
the textile fabric provisions (chapters 50 to 60) occur after the
provisions for articles of plaiting materials (chapter 46) by
operation of GRI 3(c), this product is classifiable as a textile
fabric.
Note 2 to Chapter 59, Harmonized Tariff Schedule of the
United States, (HTS), defines the scope of heading 5903, under
which textile fabrics which are coated, covered, impregnated, or
laminated with plastics are classifiable. Note 2 states in part
that heading 5903, HTS, applies to:
(A) Textile fabrics, impregnated, coated, covered or laminated with plastics, whatever the weight per square meter
and whatever the nature of the plastics material (compact or
cellular), other than:
(1) Fabrics in which the impregnation coating or covering cannot be seen with the naked eye (usually chapter 50 to 55, 58 or 60); for the purpose of this provision, no account should be taken of any resulting change in color;
Since the coating or lamination on the fabric sheets submitted is
not visible to the naked eye, it is not considered a coated fabric
for the purposes of classification as a coated or laminated fabric
in heading 5903, HTS.
The applicable subheading for the plain woven fabric will be
5407.20.0000, Harmonized Tariff Schedule of the United States
(HTS), which provides for woven fabrics of synthetic filament yarn,
including woven fabrics obtained from the materials of heading
5404, woven fabrics obtained from strip or the like. The duty rate
will be 10.2 percent ad valorem.
This fabric falls within textile category designation 620.
Based upon international textile trade agreements products of China
are subject to quota and the requirement of a visa.
The designated textile and apparel categories may be
subdivided into parts. If so, visa and quota requirements
applicable to the subject merchandise may be affected. Part
categories are the result of international bilateral agreements
which are subject to frequent renegotiations and changes. To
obtain the most current information available, we suggest that you
check, close to the time of shipment, the Status Report on Current
Import Quotas (Restraint Levels), an internal issuance of the U.S.
Customs Service, which is available for inspection at your local
Customs office.
This ruling is being issued under the provisions of Part 177
of the Customs Regulations (19 C.F.R. 177).
A copy of the ruling or the control number indicated above
should be provided with the entry documents filed at the time this
merchandise is imported. If you have any questions regarding the
ruling, contact National Import Specialist Alan Tytelman at 212-466-5896.
Sincerely,
Robert B. Swierupski
Director,
National Commodity
Specialist Division